MovinCool Classic 40 - Manual (Page 12)

12
INSTALLATION (cont.)
Choosing an Installation Site
CAUTION: Following are some precautions to consider before
choosing your installation site. Please review carefully as improper
installation may result in personal injury or damage to the unit.
1. Do not use the unit in areas where leakage of flammable gas may occur.
2. Do not use the unit in an environment which contains excessive amounts of
corrosive gas or vapor.
3. Do not place obstacles near the air inlet and outlet. Insufficient air flow may
activate the protection device or result in insufficient cooling.
4. Install the unit level with no more than 1.5 ° incline.
5. Install the unit in areas that can with-stand the weight of the unit. The Classic
40 unit weighs approximately 344 lb (156 kg), and the Classic 60 unit weighs
approximately 474 lb (215 kg).
6. Allow 18.0 in (457 mm) of unobstructed airflow for both the air inlets and
outlets.
7. Do not use the unit at condition below 75 °F (24 °C) or above 113 °F (45 °C)
50 %RH.
8. Provide proper ventilation if the unit is installed in an enclosed area.