MovinCool Classic 40 - Manual (Page 13)

13
INSTALLATION (cont.)
Plugging in the Unit (For Classic 40 ONLY)
1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/
or dirt are present, wipe off with a clean, dry cloth.
2. Check the power cord, plug and prongs for damage or excess play. If any
damage or excess play is found, contact your MovinCool reseller or a qualified
technician for repair.
WARNING:
1. If the power cord or plug is damaged, repair should only be
performed by qualified electrical personnel.
2. Do not connect/disconnect the power cord or attempt to operate
buttons with wet hands. This could result in electrical shock.
3. The power supply should be a dedicated single outlet circuit with a
UL approved short-circuit and ground fault protective breaker with
a recommended fuse size of 25 A (25 A maximum).
4. Because of potential safety hazards under a certain condition, we
strongly recommend against the use of an extension cord.
However, if you still elect to use an extension cord, it is absolutely
necessary that it is a UL listed, 4-wire grounding type appliance
extension cord, having a 4-blade grounding plug and a 4-slot
receptacle that plugs into the appliance. The marked rating of the
extension cord should be 220 V, 25 Aor equivalent.
CAUTION: The AC outlet should be rated minimum 25 A at 220 VAC, 3
phase, 60 Hz. Do not share the outlet with any other instrument or
equipment.
Note:
1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign
matter.
2. The Classic 40 is equipped with an approved NEMA plug configuration (L15-
30). The appropriate outlet must be used for this plug type.