Orion System VCM-X E-BUS Component - Manual (Page 83)

VCM-X Component & Systems Wiring 83
Communication Devices
Power/Comm Board Wiring For Local Loops
Figure 61: OE365-01 Power/Comm Board Wiring When Used For Local Loop Devices
Notes:
1.) All wiring to be in accordance with local and national electrical codes
and specifications.
2.) All modular power/comm cables are to be WattMaster part number
PCC-xx or PCCE-xx cables. All other communication wiring to be 2
conductor twisted pair with shield (Belden #82760 or equivalent).
Power/Comm Cable Power/Comm Board,
System Manager, Or Modular VAV/Zone Controller On Local Loop
If This Is The First Power/Comm Board On The Local Loop,
No Connection Is Required. See Note 2.
From Other
Power/Comm Cable To Power/Comm
System Manager, Or Modular VAV/Zone Controllers On Local Loop Only.
Other Board(s),
Connect To Modular VAV/Zone Controller
If This Is First Power/Comm Board
On Local Loop - Otherwise No
Connection Is Required. See Note 2.
FILENAME
DATE: B. Crews
DESCRIPTION: PAGE
DRAWN BY:
Local Loop Wiring Diagram
JOB NAME
02/11/2004
O-Pwr-CommWire1A.CDR
OE365-01 Orion Power/Comm Board
1 of 2
TB2
VA
C
F1
25
4A
24 SHLD T R
POWER
LD1
TB1
C1
POWER & COMM DIST
. BOARD
YS101856 REV
. 0
P5 P4 P3 P1
D1
V1
R1
P2
COMMPIN
POWER & COMM
OUT
Line Voltage
24VAC
R
SH
T
R
SH
T
R
SH
T
R
SH
T
All Comm Loop Wiring Is
Straight Thru Local Loop RS-485
9600 Baud
Local Loop RS-485
9600 Baud
24VAC Transformer (By Others)
See System Configuration Installation &
Commissioning Section Of This Manual
For Detailed Sizing Information
4 Amp Slow Blow Fuse
WARNING!
DO NOT GROUND THE 24V TRANSFORMER
THAT IS TO BE USED WITH THE POWER/COMM
BOARDS. GROUNDING OF THE TRANSFORMER
WILL DAMAGE THE POWER/COMM BOARD
AND ALL BOARDS CONNECTED TO IT. A
SEPARATE TRANSFORMER MUST BE USED
FOR EACH POWER/COMM BOARD. NO
EXCEPTIONS. DO NOT CONNECT ANY OTHER
DEVICES TO THE TRANSFORMER USED FOR
THE POWER/COMM BOARD!
Note:
Diagram Shown Is For Wiring Of
Power/Comm Board When Used
For Connecting Local Loop Devices
Such As Modular VAV/Zone
Controllers, System Manager(s) and
Other Power/Comm Boards. See
Page 2 Of This Drawing For Wiring
When Power/Comm Board Is Used
For Connection Of MiniLink Polling
Devices On The Network Loop.
CAUTION!
No Can Be
Connected To The Same
Power/Comm Board(s) That
Are Used To Supply Power
And Communications For
Modular VAV/Zone
Controllers And System
Manager On The Local Loop.
MinLink PDs