SONOSAX SX-M32 - Manual (Page 10)

User manual SONOSAX SX-M32 Page 10 of 25
4.2 RIGHT SIDE PANEL
Every user has its own requirements for connecting its audio devices together. Thus, a choice or output panels
have been foreseen during the development of the SONOSAX SX-M32, offering different interconnecting solutions
to better deserve the specific needs of each user.
The output panel is installed at factory during the assembly of the mixer. Therefore the choice of the output panel
must be specified at the order. However it can be retrofitted by qualified personal at later date.
Whatever panel is chosen it always contains following connections:
♦ Main outputs Left & Right, balanced, transformer-less [OUTPUTS]
♦ Subsidiary Stereo output [SUB OUT] with selectable line level or attenuated level [ATT]
♦ Subsidiary Mono output [MONO OUT] with selectable line level or attenuated level [ATT]
♦ Digital main output [AES] with selection of the sampling rate
♦ Monitor Headphone output on a 6,35mm ( 1/4 " ) stereo jack
♦ Adjustable Monitor return input [RETURN] with possibility to re-inject the return on the mix bus
Depending on the chosen options, the direct outputs Pre and Post Fader of the channels are also available on
these right panels.
NOTE:
The mating cable connector for the Return, the stereo and mono Sub-Outs and the AES out
is a mini XLR type TA-3F female, available under SONOSAX SX 860266
4.2.1 Main outputs, standard version [ OUTPUTS ]
The two main outputs are electronically balanced, transformer-less. Their nominal output level must be specified at
the order and can be is either +6dBu or +4dBu. This output impedance is lower than 50 ohms.
The nominal output level corresponds to the "0 Peak" on the main modulometre. It is factory programmed and and
not be changed by the user.
The main output connectors are XLR3-Male, where:
Pin1 = Gnd / Pin2 = High (+) / Pin3 = Low (-).
To connect the main output on an unbalanced receiver's input, pin 1 & 3 must be bridged and connected to the
Gnd of the receiver's input. For an unbalanced connection it is preferable to use the Sub-Out or the Mono-Out.
NOTE:
The outputs of the SX-M32 are protected against DC power. However we strongly recommend not
connecting a phantom power onto the output of the mixer (for example when connecting to the
input of a camera, make sure that the phantom power of the camera is turned off)