H3C Technologies H3C LSWM1WCM10 Access Controller Module - Manual (Page 17)

10
Connecting the console cable
Step1 Connect the DB-9 female connector of the console cable to the serial port of the PC.
Step2 Connect the RJ-45 connector of the console cable to the console port of the access controller module or
the switch.
Setting terminal parameters
Step 1: Launch a terminal emulation program on a PC, for example, Terminal under Windows 3.1 and
HyperTerminal under Windows 95/98/NT/2000/XP.
Step 2: Set the parameters for the console terminal as follows:
• Bits per second: 9600
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
• Terminal emulation: VT100
Follow these steps to set the parameters:
1. On the PC, select Start > All Programs > Accessories > Communications > HyperTerminal. The
Connection Description dialog box appears.
Figure 8 Set up a new connection
2. Type a name, test in this example, for the new connection in the Name field and click OK. The
Connect To dialog box appears.