Grass Valley Kaleido-X (7RU) v.7.70 - Manual (Page 58)

46
Kaleido-X (14RU) Expansion
Expanding NEW Kaleido-X Frames
Alarms may appear in the dashboard (see below), and, in some cases, you may see
blinking LEDs on the KXO cards in Frame B. This is normal.
11 Wait 5 minutes (this allows some important internal processing to take place), and then
continue with the procedure
1
as described in Part B — XAdmin Settings below.
Frame B will not boot completely at this stage. This is normal.
Part B — XAdmin Settings
At this point, Frame A should be up and running, with all input, output, network and serial
cables in position, and Frame B should not be rebooted.
Prior to expansion, each frame and all KXO cards normally have unique IP addresses. You
will use XAdmin to:
• specify one IP address for the expanded system;
• verify that there are no conflicts among the IP addresses of the KXO cards;
• make sure that all IP addresses are on the same subnet.
1 Open XAdmin for Frame A (refer to Opening XAdmin, in the Kaleido-X User’s Manual).
2 On the System Configuration page, select Enable expansion.
1.Even if, as in some cases, Frame B does not completely reboot.
Select the check
box to enable
expansion mode
Click here to
view this page
This button
becomes
available after
you click Save.