Grass Valley Kaleido-X (7RU) v.7.70 User Manual

Page 73

Advertising
background image

61

Kaleido-X (7RU)

Hardware Description & Installation Manual

9 Power up both frames.

Alarms may appear in the dashboard (see below), and, in some cases, you may see
blinking LEDs on the KXO cards in Frame B. This is normal.

Once the frames have rebooted, wait 5 minutes (this allows some important internal
processing to take place) and then continue with the procedure

1

as described in

Part B

— XAdmin Settings

below.

Frame B will not boot completely at this stage. This is normal.

Part B — XAdmin Settings

At this point, Frame A should be up and running, with all input, output, network and serial
cables in position, and Frame B should not be rebooted. Prior to expansion, each frame and
all KXO cards normally have unique IP addresses. You will now use XAdmin to:

• specify one IP address for the expanded system

• verify that there are no conflicts among the IP addresses of the KXO cards

• make sure that all IP addresses are on the same subnet

1 Open XAdmin for Frame A (refer to Opening XAdmin, in the Kaleido-X User’s Manual).

2 On the Status and Options page, select Enable expansion.

1.Even if, as in some cases, Frame B does not completely reboot.

Connect EXP LINK 1 on FRAME A

to EXP LINK 1 on FRAME B

Connect EXP LINK 2 on FRAME B

to EXP LINK 2 on FRAME A

Advertising