Grass Valley Karrera Video Production Center Installation v.4.1 User Manual
Page 100
100
KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
Figure 58. Frame Network Address Web Page
3.
Under Facility LAN, type in the new IP address (and subnet mask and
gateway if needed). Make sure you enter the correct number exactly. A
typing error can make the frame inaccessible over the network, since
you need to know its IP address for use with the Web browser.
Note
If you make a mistake, you can use the Serial Port and Terminal method to
view the existing Video Processor frame IP address and change then to the
correct values.
4.
Click on the
Save New Settings
button.
5.
Reset the device.
•
A Video Processor Frame can be reset by pressing the
Reset
button
on the Video Processor Frame Control Processor module.
•
A Control Panel can be reset using EMEM area buttons. Press
Menu
,
Page,
select
IP Addr
(press
Lrn
), select
Boot Panel
(press
Bank 3/7
) and
then select
Yes
(press
7
). See Setting The Control Panel’s IP Address
for more information.
The device will boot up with the new IP address.
When a Video Processor Frame IP address has been changed, communica-
tions will no longer occur with any Karrera system devices that are config-