HEIDENHAIN ND 1200T - Manual (Page 48)

Chapter 2 Operation
2-22
Measuring an angle
Angles can be measured by targeting between 2 and 100 points
on each of the vertices of the angle. Generally, accuracy of the
feature is increased as more points are targeted and the targeted
points are distributed at more or less equal distances along the
line.
NOTE NOTE NOTE NOTE NOTE
The procedure below assumes that angle data is required for a
The procedure below assumes that angle data is required for a The procedure below assumes that angle data is required for a The procedure below assumes that angle data is required for a The procedure below assumes that angle data is required for a
saved tool. If angle data is required for simple verification or
saved tool. If angle data is required for simple verification or saved tool. If angle data is required for simple verification or saved tool. If angle data is required for simple verification or saved tool. If angle data is required for simple verification or
other purposes, press the angle feature selection key and proceed
other purposes, press the angle feature selection key and proceed other purposes, press the angle feature selection key and proceed other purposes, press the angle feature selection key and proceed other purposes, press the angle feature selection key and proceed
from step 2.
from step 2. from step 2. from step 2. from step 2.
To measure an angle
Step 1
Press the Angle feature selection key. Be certain there is not a
tool selected. If a tool name appears at the top of the screen
press the Quit command key followed by Angle feature selection
key. The Probe Line 1 screen will be displayed.