HEIDENHAIN IK 5293 - Manual (Page 214)

200
Chapter 5 Advanced Measuring & Output
Step 3
Type the nominal X and Y values for your part in the boxes as shown.
Step 4
Enter the specified diameter as shown.
Step 5
Type in the nominal + and nominal - values for your feature as shown.
NOTE NOTE NOTE NOTE NOTE
Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for
the feature. F
the feature. F the feature. F the feature. F the feature. For example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or -
0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006
inches.
inches. inches. inches. inches.