Yaskawa 120 Series I/O Modules - Manual (Page 104)

3 Digital I/O Specifications
3.3.6 W5410 Cables (Model No. JEPMC-W5410-††)
3-74
3.3.6 W5410 Cables (Model No. JEPMC-W5410-††)
1) Use
(1) This Cable is used to connect external devices to the Modules listed below.
(a) 12/24-VDC 64-point Input Module (Model No. JAMSC-120DDI36400)
(b) 12/24-VDC 64-point Output Module (Model No. JAMSC-120DDO36410)
(c) Register Input Module (Model No. JAMSC-120RDI34410)
(d) Register Output Module (Model No. JAMSC-120RDO34410)
(2) The end of the Cable to the external device is loose wires.
2) Specifications
The following table shows specifications of W5410 Cables.
3) Appearance
The following illustration shows the appearance of a W5410 Cable.
Table 3.9 Specifications of W5410 Cable
Item Specifications
Model Name W5410-05 W5410-10 W5410-30
Model No. JEPMC-W5410-05 JEPMC-W5410-10 JEPMC-W5410-30
Length L 0.5 m 1.0 m 3.0 m
Cable
Specifications
Shielded cable, 40 cores, AWG24 (0.20 mm 2 )
Cable
Termination Module
side Connector: FCN-363J-040 (Fujitsu Ltd.)
FCN-360C040-B (Fujitsu Ltd.)
FCN-363J-AU/R (Fujitsu Ltd.)
External
device
side Loose wires: Wire length 100 mm with pin number label on
each wire.
Insulation
Resistance 100 M Ω min. at room temperature and humidity between core wires
(connected together) and shielding wire, and between core wires
(measured with a 500-VDC test voltage megohmmeter).
A pin number label is on
each loose wire.
L 100 mm
Model name
Connector (Module side)
Shield cable
Loose wires (external device side)
40-core
loose wires