Extron electronic P/N 68-412-02 - Manual (Page 7)

Extron • System 4 xi Switcher Series • User’s Manual • P/N 68-412-02 Rev. A
Configuration and Connections Hughes Installation
Page 6
"A" ADP UNV "A"
26-467-01
5. The Hughes Adapter has two 9-pin connectors, one male and one female. Plug
the 9-pin female connector onto the 9-pin male marked “Control Out” (Port B) on
the Hughes projector back panel.
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(CC 50' or CC 100') into the PJ Comm port on the System 4
xi
. The other end
has a 9-pin female connector. Plug this end into the other 9-pin male D
connector on the HU COM Adapter.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4 xi output and those on the other end onto the matching
BNCs on the Hughes panel.
System 4 xi Series – Hughes-JVC DILA Projector Connections
Use the illustration below as a guide when connecting the System 4 xi to a
Hughes-JVC DILA projector. Refer to Hughes documentation to continue the
installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4 xi . See page 2-5 for cabling guidelines.