Exmark Turf Tracer x-series LP FMD524 - Manual (Page 29)

Maintenance
pressures within the above range to try to make
tire circumferences match as closely as possible.
Semi-pneumatic caster tires do not need to be
inflated.
Note: Do Not add any type of tire liner or foam
fill material to the tires. Excessive loads created by
foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling
tires will void the warranty.
Check Condition Of Belts
Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Remove the three mower deck belt shields
to check mower primary and secondary belt
condition.
3. Look under engine deck to check the pump drive
belt condition.
4. Check all idler arms to be sure they pivot freely.
Lubricate Grease Fittings
Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with one to two pumps of
NGLI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of
Places
Service
Interval
1. Front
Caster
Wheel Hubs *0 2 *Yearly
2. Front
Caster
Pivots *0 2 *Yearly
3. Idler
Pivots
(Mower
Deck) 1 2 Yearly
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of
Places
Service
Interval
4. Idler
Pivot (Pump
Drive) 2 1 Yearly
5. Hydro
Control
Arm
Support
Bushings 2 2 40 Hours
* See step 3 for special lubrication instructions on
the front caster pivots and the Lubricate Caster
Wheel Hubs section for special lubrication
instructions on the front casters wheel hubs.
Number 4 (Idler Pivot (Pump Drive) Located
Under Engine Deck
3. Lubricate front caster pivots once a year. Remove
hex plug and cap. Thread grease zerk in hole and
pump with grease until it oozes out around top
bearing. Remove grease zerk and thread plug back
in. Place cap back on.
Lubricate Caster Wheel Hubs
Service Interval: Yearly
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
29