Safety – Exmark Turf Tracer x-series LP FMD524 User Manual

Page 9

Advertising
background image

Safety

DANGER

Operating on wet grass or steep slopes can
cause sliding and loss of control. Loss of control
and/or loss of operator’s footing could result in a
fall with an arm or leg getting under the mower
or engine deck which may result in serious
injury, death or drowning.

Mow across slopes, never up and down.

Do Not mow slopes when grass is wet.

Do Not mow near drop-offs or near water.

Do Not mow slopes greater than 20 degrees.

Reduce speed and use extreme caution on
slopes.

Avoid sudden turns or rapid speed changes.

See inside the back cover to determine the
approximate slope angle of the area to be mowed.

Remove or mark obstacles such as rocks, tree
limbs, etc. from the mowing area. Tall grass can
hide obstacles.

Watch for ditches, holes, rocks, dips and rises that
change the operating angle, as rough terrain could
overturn the machine.

Avoid sudden starts when mowing uphill because
the mower may tip backwards.

Be aware that operating on wet grass, across steep
slopes or downhill may cause the mower to lose
traction. Loss of traction to the drive wheels may
result in sliding and a loss of braking and steering.

Always avoid sudden starting or stopping on a
slope. If tires lose traction, disengage the blades
and proceed slowly off the slope.

Follow the manufacturer’s recommendations for
wheel weights or counter weights to improve
stability.

Use extreme care with grass catchers or
attachments. These can change the stability of the
machine and cause loss of control.

Maintenance and Storage

Disengage drives, lower implement, set parking
brake, stop engine and remove key or disconnect
spark plug wire. Wait for all movement to stop
before adjusting, cleaning or repairing.

Keep engine and engine area free from
accumulation of grass, leaves, excessive grease

or oil, and other debris which can accumulate
in these areas. These materials can become
combustible and may result in a fire.

Let engine cool before storing and Do Not store
near flame or any enclosed area where open pilot
lights or heat appliances are present.

Store mower in a well ventilated outdoor shelter,
building, or trailer.

Close fuel valve when mower is not in use,
including while storing or transporting.

The empty tank(s) should be treated as if it was
full.

Store the tank(s) outside of buildings in an open
well ventilated area, away from spark and flames.

Do Not store the tank(s) or machine with
tank(s) in an area where the temperature can rise
above 120°F (49°C). If the temperature exceeds
approximately 160°F (71°C), the tank will release
highly flammable propane vapor. See Preparation
in the Safety Section.

Store the tank(s) in upright position or with
pressure relief valve towards the top.

Do Not drag, drop, or abuse the tank(s).

Storage of the empty tank(s) should follow local
and state regulations.

Park machine on level ground. Never allow
untrained personnel to service machine.

Use jack stands to support components when
required.

Carefully release pressure from components with
stored energy.

Disconnect battery or remove spark plug wire
before making any repairs. Disconnect the
negative terminal first and the positive last.
Reconnect positive first and negative last.

Use care when checking blades. Wrap the blade(s)
or wear gloves, and use caution when servicing
them. Only replace damaged blades. Never
straighten or weld them.

Keep hands and feet away from moving parts.
If possible, Do Not make adjustments with the
engine running.

Charge batteries in an open well ventilated area,
away from spark and flames. Unplug charger
before connecting or disconnecting from battery.
Wear protective clothing and use insulated tools.

9

Advertising
This manual is related to the following products: