Retrotec Flow Finder MK 2 - Manual (Page 9)

Page 9 of 17
M:\PDF\Source\Manual-FlowFinder mk2\Manual-FlowFinder mk2.docx © Retrotec Inc. 2014
5. Switching on the FlowFinder
Press the On/off push button is on the lower left hand side of the
panel to start the FlowFinder. It will start up in one of two measuring
modes: “Validate” and “Adjust”. See Section 6.3 to choose.
Start up in Validate Mode will look like this:
The display will show “- - -” and the parameters will be as shown below.
Time and date
Pressure difference to
be compensated
Status battery pack
Temperature
Humidity
Measured flow in
m3/hr, l/s or CFM,
here m3/h
USB connected?
(only for service)
Horizontal bar graph
(0 to 1000 m3/h) of
the measured flow
SD card present? green!
not present? red..
Ready to measure in “Validate” mode