Figure 3-4 formica surface arrangement, Figure 3-5 leveling the console, 6 formica writing surface arrangement – EFJohnson VR-CM50 User Manual
Page 29: 7 writing support rail mounting
![background image](/manuals/84481/29/background.png)
CABINETRY ASSEMBLY FOR CRT CONSOLE SYSTEMS
3-3
February 1996
Part No. 004-3039-274
Figure 3-4 FORMICA SURFACE ARRANGEMENT
2. Mark the console face where the breaks occur in the
Formica writing surface. The marks should be
made below the writing surface plane so that they
will be hidden when the Formica is installed.
3.7 WRITING SUPPORT RAIL MOUNTING
The writing support rails are necessary for
mounting and providing support to the Formica writ-
ing surfaces of consoles. One support rail is provided
for each side-by-side cabinet bay consisting of two or
more consoles including pie-shaped pieces. For two-
bay cabinetry, one support rail is provided at each end
and in the middle. For convenience, the rails and their
mounting locations are numbered.
1. Install the writing support rail number at the corre-
sponding location number found on the side of the
console frame.
Figure 3-5 LEVELING THE CONSOLE
3.6 FORMICA WRITING SURFACE ARRANGE-
MENT
1. Locate all writing surface Formica and arrange on
the floor in front of console. A typical layout is
shown in Figure 3-4. Permanent mounting can be
accomplished more easily if the Formica is arranged
on the floor directly in line to its mounting position
on the console.