Controls and installation, cont’d – Extron Electronics P-2 DA2 WM F, WM F AAP, EC F, D User Manual

Page 10

Advertising
background image

P/2 DA2 WM/EC/D/AAP Series • Controls and Installation

P/2 DA2 WM/EC/D/AAP Series • Controls and Installation

2-8

Controls and Installation, cont’d

6

Power up all of the input and output devices.

7

The image should now display on screen. If it does not,
double check steps 3 through 6 and make adjustments as
needed. Refer to the section “Setting the DIP switches” in
this chapter.

8

For the P/2 DA2 WM F, attach the P/2 DA2 WM F to the
wall mounting bracket (see “Installing the mud ring
bracket”).

For the P/2 DA2 WM EC F, attach the P/2 DA2 WM F EC
to the Euro Channel (see “P/2 DA2 WM EC F Euro
Channel installation”).

Installing the mud ring bracket

1.

Once the proper wall location for mounting the
distribution amplifier has been determined, cut an opening
in the wall using the proper mounting template found in
the appendix.

2.

Carefully cut away the mounting surface material inside
the traced template lines.

3.

Test the fit of the mud ring. The doglegs should fit easily
into the hole and the flat portion should rest flush against
the wall. See the note in the following illustration.

4.

Rotate all doglegs inward.

5

.

Insert the mud ring into the hole.

6.

Tighten all of the dogleg screws until the doglegs clamp
the mud ring to the mounting surface. Do not
overtighten.

Standard mud rings only:

If you are going to screw the

mud ring to the surface, rather than using the detachable
doglegs, mark the four surface mounting screw holes at
the corners of the mud ring.

Rotate doglegs
and insert mud
ring into wall
opening.

Extron
MR 200D

Modular Mud Ring

Surface Mounting
Hole

Dogleg
Screw

Equipment Mounting
Holes

NOTE

Do not disassemble the dogleg

from the dogleg screw. Rotate the
dogleg out of the way to insert the
mud ring into the wall.

Installing a mud ring bracket

2-9

Advertising
This manual is related to the following products: