Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 43)

Avago Technologies
- 43 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
Figure 24 LSIiBBU07 Unit and Components
1. J4 Battery Pack Harness Connector
2. J5 Board-to-Board Connector
3. J2 Connector
4. Battery Pack Harness
2.4.2 Installing the LSIiBBU07 Unit Directly on a RAID Controller
This section describes how to install the LSIiBBU07 unit directly on the MegaRAID SAS 8888EM2 RAID controller.
Perform the following tasks described in this section, in order, to connect the LSIiBBU07 unit directly to the RAID
controller:
1. To remove the RAID controller, see Section 2.4.2.1, Removing the RAID Controller from the Computer .
2. To install the LSIiBBU07 unit on the RAID controller, Section 2.4.2.2, Installing the LSIiBBU07 Unit on the RAID
Controller .
3. To reinstall the RAID controller, see Section 2.4.2.3, Reinstalling the RAID Controller on the Motherboard , on
page 45 .
CAUTION Electrostatic discharge (ESD) can damage the LSIiBBU07 unit and the
MegaRAID SAS RAID controller. Make sure that you install the
LSIiBBU07 unit at an ESD-safe workstation that meets the
requirements of EIA-625 (Requirements For Handling Electrostatic
Discharge Sensitive Devices). When you install the LSIiBBU07 unit,
follow the ESD-recommended practices in the latest revision of the
IPC-A-610 (Acceptability of Electronic Assemblies) standard.
85021-05
(Rear View)
(Front View)
J4
J5
J2
4
1
2
3
4