Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 93)

Avago Technologies
- 93 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Connecting a CVFM02 Module on a RAID Controller to a CVPM02 Module Mounted on a
Remote Mount Board
2.9.4 Connecting the CVFM02 Module to the Remote CVPM02 Module
Follow these steps to connect the CVFM02 module on the MegaRAID SAS 9266-8i RAID controller by cable to the
CVPM02 module on the remote mount board.
1. With the controller on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
2. Remove the cable that is included in the RAID controller box.
3. Insert the smaller of the two 6-pin cable connectors on the cable into the 6-pin J2B1 cable connector on the
CVFM02 module, as shown in the following figure.
4. Insert the larger of the two 6-pin cable connectors on the other end of the cable into the 6-pin cable connector on
the remote CVPM02 module.
5. Align the cable connectors to make sure that they are connected correctly.
Figure 62 Connecting the CVFM02 Module on the RAID Controller to the Remote CVPM02 Module
3_00894-00
J2B1