Avago Technologies SAS 9200-8e Host Bus Adapter - Manual (Page 23)

LSI Corporation
- 23 -
PCI Express to 6Gb/s Serial Attached SCSI (SAS) Host Bus Adapters User Guide
May 2013 Host Bus Adapter Characteristics
Characteristics of the LSI 6Gb/s HBAs
3.1.8.4 Physical Characteristics
The LSISAS9201-16i HBA is 6.6-in. × 4.2-in. The component height on the top and bottom of the LSISAS9201-16i board
is in accordance with the PCIe specifications.
Figure 9 LSISAS9201-16i Board Layout
 EC1: PCIe x8-lane board edge connector
 J6, J7, J8, J9: SFF-8087 mini-SAS, internal, right-angle connectors
 J4 and J5: 4-pin, right angle, 0.1-in. pitch pin header for driving external activity LED
 J1: UART connection
3.1.9 LSISAS9202-16e HBA Characteristics
The LSISAS9202-16e HBA supports active copper cable and passive copper cable.
3.1.9.1 Memory
The LSISAS9202-16e HBA provides two 4-M × 8-bit Flash ROMs for storing the firmware and BIOS.
3.1.9.2 LEDs
The two LSISAS9202-16e HBA heartbeat LEDs, CR1 and CR2, blink green to indicate that the HBA is capable of
general activity.
3.1.9.3 Connectors
This section describes the different connectors on the LSISAS9202-16e HBA. See Figure 10 for connector locations.
PCIe Connector (EC1). The LSISAS9202-16e HBA supports a x16 interface. The PCIe host interface connection is
through the edge connector, EC1, which provides connections on both the top (EC1B) and bottom (EC1A) of the
board. The signal definitions and pin numbers conform to the PCIe specification.
SAS/SATA Connector (J3). The LSISAS9202-16e HBA supports SAS connections through four external connectors: J3,
ports A, B, C, and D, which are SFF-8644 mini-SAS HD, external, right-angle connectors.
%#
*
?

*
0ORT
0ORT
0ORT
0ORT
*
*
*
*
*
,3)3!3