Avago Technologies SAS 9200-8e Host Bus Adapter - Manual (Page 27)

LSI Corporation
- 27 -
PCI Express to 6Gb/s Serial Attached SCSI (SAS) Host Bus Adapters User Guide
May 2013 Host Bus Adapter Characteristics
Characteristics of the LSI 6Gb/s HBAs
3.1.11.4 Physical Characteristics
The LSISAS9207-8e HBA is a 6.6-in. × 2.7-in., low-profile board. The component height on the top and bottom of the
LSISAS9207-8e HBA is in accordance with the PCIe specification. The following figure shows the board connectors.
Figure 12 LSISAS9207-8e Board Layout
 EC1: PCIe x8-lane board edge connector
 CR1: Heartbeat LED
 J4: UART connection
 J10, J11: SFF-8088 mini-SAS, external, right-angle connectors
3.1.12 LSISAS9207-8i HBA Characteristics
3.1.12.1 Memory
The LSISAS9207-8i HBA provides one 4 M × 16-bit Flash ROM for storing the firmware and BIOS.
3.1.12.2 LED
The LSISAS9207-8i HBA heartbeat LED, CR1, blinks green to indicate that the HBA is capable of general activity.
3.1.12.3 Connectors
This section describes the different connectors on the LSISAS9207-8i HBA. See Figure 13 for connector locations.
PCIe Connector (EC1). The LSISAS9207-8i HBA supports a x8 interface. The PCIe host interface connection is through
the edge connector (EC1) which provides connections on both the top (EC1B) and bottom (EC1A) of the board. The
signal definitions and pin numbers conform to the PCIe specification.
SAS/SATA Connectors (J5 and J6). The LSISAS9207-8i HBA supports SAS/SATA connections through connectors J5
and J6, which are SFF-8087 mini-SAS, internal connectors. The HBA supports SAS sideband signal assignments.
?

*
*
,3)3!3
*
#2
%#