Sony BDP-S1700 Blu-ray Disc Player - Manual (Page 48)

48 GB
• If sound is still not output or if sound is
interrupted, connect the optical digital
audio cable (not supplied) and set on the
receiver “<HDMI>” – “CTRL.HDMI” – “CTRL
OFF”.
• If the TV is not compatible with the eARC
or ARC function, connect the receiver to
the TV using an optical digital audio cable
(not supplied) or a stereo audio cable
(not supplied). There will be no TV sound
from the connected speakers when the
receiver is connected to an HDMI input
jack of a TV that is not compatible with
the eARC or ARC function.
• Be sure to select the correct device or
input when watching a program from a
device connected to the TV. Refer to the
section on this operation in the operating
instructions of the TV.
• If the sound of a cable box or satellite box
connected to the TV is not output,
connect the device to an HDMI input jack
of the receiver and switch the input of the
receiver to the input for the connected
device (page 29).
• Depending on the order in which you
connect the TV and the receiver, the
receiver may be muted and “MUTING” is
displayed on the display panel of the
receiver. If this happens, turn on the TV
first, then the receiver.
No sound is output from the TV when
the receiver is in standby mode.
• When the receiver enters standby mode,
sound is output from the last HDMI
device selected before you turned off the
receiver. If you are enjoying content from
another device, play the content on the
device and perform the One-Touch Play
operation, or turn on the receiver to
select the HDMI device from which you
want to enjoy content.
• Make sure “STBY.THRU” is set to “ON” or
“AUTO” in the “<HDMI>” menu.
No sound or only a very low level of
sound is heard, no matter which
device is selected.
• Check that all connecting cables are
inserted to their input/output jacks on
the receiver, speakers and the devices.
• Check that the receiver and all devices
are turned on.
• Check that MASTER VOLUME on the
receiver is not set to “VOL MIN”.
• Press SPEAKERS on the receiver to select
a setting other than “OFF SPEAKERS”
(page 46).
• Check that headphones are not
connected to the receiver.
• Press

(muting) to cancel the muting
function. “MUTING” disappears from the
display panel.
• Try pressing the input button on the
remote control or turning INPUT
SELECTOR on the receiver to select the
input to which you want to listen.
• The protective device on the receiver has
been activated. Turn off the receiver,
eliminate the short-circuit problem, and
turn on the power again.
There is severe humming or noise.
• Check that the speakers and device are
connected securely.
• Make sure that the connecting cables are
not near a transformer or motor.
• Move your audio device away from the
TV.
• If the plugs and jacks are dirty, wipe them
with a cloth slightly moistened with
alcohol.
Audio