Eurotech Appliances EWF272EL - Manual (Page 21)

21 Specifications are subject to change without notice. See owner’s manual for additional details.
Dryer Installations
CONDENSER DRYER DIMENSIONS
EDC158
Technical Data
Drying system: Internal Condenser (non-venting)
Supply voltage: 208/230 V, 60 Hz
Heater loading: 2500 watt
Fuse/breaker: 30 A
WARNING!
This appliance must be properly grounded. Refer to the owner’s manual for instructions.
Installation should be carried out by a qualified person who is familiar with all local codes and
ordinances for electrical and plumbing connections. Incorrect installation may cause damage and/or
injury.
When placing the dryer next to a wall or cabinet, be sure to leave 1/2” (12 mm) of space between the
machine and the wall or cabinet. Make sure the air vents on the front of the machine are not covered.
If possible you should install the dryer so the condensed water will continuously flow into a drain or
sink. The drain outlet should be positioned no higher than 35” (889 mm) from the bottom of the unit.
Refer to the owner’s manual for instructions.
The machine can be installed in any room with a hard floor. Do not install it on carpeting with heavy pile.
The door hinges on the condenser dryer can be reversed to make loading and unloading the dryer
more convenient. Refer to the owner’s manual for instructions.
See pages 23—28 for stacked washer/dryer dimensions.
23-3/8"
594 mm
22-3/8"
568 mm
45-1/8"
1146 mm
33-1/4" 845 mm
6-3/4" 171 mm
5-1/4"
133 mm
3-1/2""
89 mm
Te
rm
ina
l
bo
x
9-3/8" 238 m
m