Extron Electronics RGB 150x - Manual (Page 15)

RGB 130xi xi xi xi xi , 134xi xi xi xi xi , 150xi xi xi xi xi Controls and Installation
Mounting the interface
To mount the interface under a desk or in a podium, do the
following:
1. Attach the mounting brackets to the interface using
six machine screws supplied with the mounting kit
(see figure 2-7).
Figure 2-7 — Attaching the under desk brackets
2. Using the to-scale template at the back of this manual
to guide you, mark the four screw holes on the
underside of the surface to which you are mounting
the interface. Use the under desk mounting
template.
3. Drill four pilot holes, each 3/32” in diameter by 1/4”
deep, where marked.
4. Using the four wood screws provided, attach the
brackets under the mounting surface (see figure 2-8).
Figure 2-8 — Mounting the interface under a
desk
2-8
BUFFERED LOCAL MONIT
OR OUTPUT
INPUT
H. SHIFT
RGB 103 xi
MA C INTERF
ACE W /ADSP
BUFFERED LOCAL MONIT
OR OUTPUT
INPUT
H. SHIFT
RGB 103 xi
MA C INTERF
ACE W /ADSP