Extron Electronics RGB 150x - Manual (Page 20)

RGB 130xi xi xi xi xi , 134xi xi xi xi xi , 150xi xi xi xi xi Controls and Installation
Controls and Installation, cont’d
2-13
3. Slide the audio cable connector into the audio output
connector on the interface.
Balanced audio
To attach the interface to a balanced audio system, do the
following:
1. Attach the audio cable to a balanced speaker input
connector (tip, ring, and sleeve).
2. Attach the audio cable to the audio cable connector
(Extron part number 10-319-10). Fasten the captive
screws inside the audio cable connector as shown in
figure 2-14.
Connect the sleeve(s) to ground (GND).
Connecting the sleeve(s) to a negative (-)
terminal will damage audio output circuits.
3. Slide the audio cable connector into the audio output
connector on the interface.
Tip (+) Sleeve
Tip (+)
Ring (-)
Sleeve
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring