Epson EQUITY 3865X/20 PLUS - Manual (Page 130)

4. If you are removing a display adapter card, you may need to
change the settings of jumpers J1 and J2. See page 6-2 for
instructions.
5. Replace the cover. See Chapter 5 for instructions.
6. See “Post-installation Setup” at the end of this chapter to
configure your computer to operate without the option card.
Adding Memory Modules
Your computer comes with 2MB of memory. By installing
SIMMs (single inline memory modules) on the main system
board, you can increase the amount of on-board memory in your
computer up to 14MB.
Caution
It is best to have your dealer install memory modules for you
because they can be damaged easily if installed incorrectly.
If you prefer, you can install your own SIMMs by carefully
following the instructions in this section. However, you could
transmit an electrostatic discharge and damage your
components; so read this entire section before you begin.
Before you install SIMMs, check the following guidelines to
ensure that they will work properly:
Use fast-page mode SIMMs that operate at 80ns
(nanosecond) access speed (or faster). Be sure all the
SIMMs have the same access speed.
Use the correct SIMM configuration to add the amount of
memory you want. See “Installing Memory Modules” on the
next page.
Once you have the SIMMs you need, you or your dealer can
install them in your computer. If you are going to install them
yourself, follow the instructions below.
6-10 Installing and Removing Options