HP FACSIMILE MACHINE HP FAX-700 - Manual (Page 71)

2Ć46 Installation and Configuration
Setting the Paper Size on the HP FAX-900 and FAX-950
Your HP Fax 900 is factory set for receiving documents using the standard paper size of the country of destination
when ordered. In the U.S. A., it is set for receiving letter - 8 1/2 in. x 11 inch documents. Where the metric system is
normally used, it is set for receiving A4 size documents.
If you want to configure to receive U.S. legal (8 1/2 in. x 14 in.) or change to receive letter (8 1/2 in. x 11 in) or A4 (210
mm x 297 mm) size documents, you will need to configure fax parameter 23 to the desired size.
To configure the received document paper size, press the buttons in the sequence shown and enter the necessary
information where requested.
Menu
7
Set
Stop Set
4
Set
2 3
1. A4
2. Letter
3. Legal
Switching the Verification Stamp ON (HP FAX-950)
Note
HP fax machines FAX-700, FAX-750, and FAX-900 do not have a verification stamp capability.
The verification stamp is a small mark
that prints at the bottom of each successfully transmitted page. The HP
FAX-950 comes from the factory with the verification stamp switched OFF. The FAX-950 can be temporarily
switched ON by pressing the
Stamp Ɵ
button . The lamp next to the button is lit when the stamp feature is ON.
After the document is sent, the fax machine automatically returns the stamp setting to its current value.
To permanently switch the verification stamp ON, change fax parameter 04 to Option 2 using the following proce-
dure:
Menu PRS Set/Volume–
Type the
numbers
04
Stop
7
Set
4
GHI
Set
Type the
number
2
Note
Normally the fax machine does not stamp originals as they are stored in memory (for later trans-
mission, for example). To switch the verification stamp ON for stored documents, you must also
set fax parameter 28 (MEMORY STORED STAMP) to Option 2.