Servicing your outboard motor – HONDA BF20D User Manual
Page 84
82
SERVICING YOUR OUTBOARD MOTOR
ENGINE COVER LATCH
UNLATCH
FUEL FILTER
FUEL FILTER
FUEL HOSE
CONNECTOR
FUEL FILTER
HOSE CLIPS
HOSE CLIPS
(commercially available)
HOSE CLAMPS
FUEL HOSES
Unlatch and remove the engine
cover for access to the fuel pump
filter.
Inspect the filter for water and/or
sediment accumulation.
If the filter is OK, reinstall it. If
water and/or sediment are present,
replace the filter as described in
the following steps. Always
replace the filter at the scheduled
replacement interval (p.
Remove the fuel hoses from the
used filter, and discard the filter.
Disconnect the fuel hose connector
from the outboard motor, and
place commercially available hose
clips on the fuel hoses on each side
of the filter to prevent fuel leakage
when the fuel hoses are
disconnected.
To ease hose removal, release the
hose clamps by squeezing the
clamp ends together with pliers
while pulling off the hoses.
3.
2.
1.
4.
07/09/19 18:29:06 31ZY0600_083