HONDA BF20D - Manual (Page 88)

2.89 lbf·ft (4 N·m)
12 lbf·ft (17 N·m)
86
SERVICING YOUR OUTBOARD MOTOR
COTTER PIN
CASTLE
NUT
THRUST WASHER
MARINE GREASE
PLAIN
WASHER
PROPELLER
COTTER PIN
TOWARD
GEAR CASE
Installation
Do not tighten the castle nut above
the TIGHTENING TORQUE LIMIT
or the propeller and shaf t may be
damaged.
TIGHTENING TORQUE LIMIT:
Remove the cotter pin, unscrew the
castle nut, remove the washer, then
remove the propeller and thrust
washer.
Apply marine grade grease to the
propeller shaft.
Install the thrust washer with the
grooved side toward the gear case.
Lightly tighten the castle nut by
hand or wrench until the propeller
has no free play.
Tighten the castle nut using torque
wrench.
Then, using a torque wrench,
tighten the castle nut until the first
available groove in the castle nut
aligns with the cotter pin hole. Do
not tighten past the first alignment
of the castle nut groove and the
cotter pin hole.
Install the propeller and the plain
washer.
Note that these wrenches are not
included with the tool set that
comes with the outboard motor.
Contact your authorized Honda
Marine dealer for additional tool
information.
Use a genuine Honda stainless
steel cotter pin or equivalent
cotter pin and bend the pin ends
as shown.
Be sure to replace the cotter pin
with a new one.
1.
2.
3.
4.
5.
6.
7.
CASTLE NUT TIGHTENING
TORQUE:
07/09/19 18:29:47 31ZY0600_087