Heartland Bakeware U109760-02 - Manual (Page 44)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
U109760-02 44
Range operational checks
Oven check
Set the clock to the time of day - the ovens will
not work if the clock is not set.
When the clock is first connected the display will
flash (
) and ( ) alternately.
To set the clock to read the time of day turn and
hold the Setting knob to the clock symbol ( )
and at the same time turn the Adjusting knob
left or right until the clock shows the time of day.
This is a 12 hour clock. Let go of the Setting
knob and it will spring back to the vertical ( )
oven manual setting.
Turn on the oven and check that the oven fan
starts to turn and that the oven starts to heat up.
Turn off the oven.
Oven Light
Press the oven light switches and check that the
lights are working.
Note. The oven light bulbs are not included in
the guarantee
Check Ignition of Cooktop Burners
Operation of all cooktop burners should be
checked after the range and gas supply lines
have been carefully checked for leaks.
Check each burner in turn. There is a flame
safety device that stops the flow of gas to the
burner if the flame goes out. There is also a
spark ignition system that works when the knob
is pressed in.
For each burner, push in and turn a knob to the
(
) lighting position.
The igniter should spark and light the gas.
Keep holding the knob pressed in to let the gas
through to the burner for few seconds.
If, when you let go of the control knob, the
burner goes out, the safety device has not held
in. Turn the control to the off position and wait
one minute, then try again this time holding in
the control knob for slightly longer.
Quality of Flames
On Natural Gas the burners flames should be
a blueish color with, at most, a slight yellowish
fringe.
On Propane gas the flames may be “softer”.
The cooktop burner flames may have a slight
yellowish tip.
If the flame burns with a long white tip you
should call for service.
Normal flame appearance Burner not fitted correctly
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
MAKE SURE ALL CONTROLS ARE LEFT IN
THE OFF POSITION.
Customer care
Please complete your details in the inside cover
of this Guide. Then replace this Installation
Guide back in the Customer Care Pack in the
correct position. Please inform the user how to
operate the range and hand over the Customer
Care Pack
Thank you.