Hearth and Home Technologies Dakota 42-CE - Manual (Page 18)

18 Heat & Glo Lifestyle Collection • Dakota 42-CE • 4036-915 Rev I • 1/07
B. Lighting the Fireplace
Electronic Ignition
LIGHTING
INSTRUCTIONS
TO TURN OFF
GAS TO FIREPLACE
1. Push the ‘OFF’ button on remote.
2. Remove batteries from receiver.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. This fi replace is equipped with
an electronic pilot ignition device
which automatically lights the
burner. Do not try to light the
burner by hand.
B. BEFORE LIGHTING, smell all
around the fi replace area for gas.
Be sure to smell next to the fl oor
because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL
GAS
• Do not try to light any appliance.
DO NOT CONNECT 240 VAC
TO THE CONTROL VALVE.
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property dam-
age. Refer to the owner’s information
manual provided with this fi replace.
This fi replace needs fresh air for safe
operation and must be installed so
there are provisions for adequate
combustion and ventilation air.
If not installed, operated, and main-
tained in accordance with the man-
ufacturer’s instructions, this product
could expose you to substances in
fuel or fuel combustion.
Keep burner and control compart-
ment clean. See installation and
operating instructions accompanying
fi replace.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture,
gasoline and other liquids having
fl ammable vapors away.
Do not operate the fi replace with
panel(s) removed, cracked or bro-
ken. Replacement of the panel (s)
should be done by a licensed or
qualifi ed service person.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas sup-
plier, call the fi re department.
C. Do not use this fi replace if any part
has been under water. Immediately
call a qualifi ed service technician to
inspect the fi replace and to replace
any part of the control system and
any gas control which has been
under water.
NOT FOR USE
WITH SOLID FUEL
For use with natural, propane and
butane gases.
WARNING:
1. This fireplace is equipped with an
ignition device which automatically
lights the burner. Do not try to light
the burner by hand.
2. Wait fi ve (5) minutes to clear out any
gas. Then smell for gas, including
near the fl oor. If you smell gas, STOP!
Follow “B” in the Safety Information
located on the left side of this label. If
you don’t smell gas, go to next step.
3. To light the burner, simultaneously
press the star and up arrow
buttons on the remote control until a
short acoustic signal confi rms the start
sequence has begun.
4. If the fi replace will not operate, check
the batteries then follow the instruc-
tions “To Turn Off Gas to Fireplace”
and call your service technician or gas
supplier.