Tsurumi TPG-2900H-DX User Manual
Page 50
(3) Installation of Fuel Tank.
(a)
Install parts that were removed from the previously installed tank on the replacement
tank.
(b) Slip the flange on the fuel tank into the channel on the back of the front panel (29).
(c)
Install two bolts (H-9) and washers (H-10) to secure fuel tank. Tighten fasteners.
(d) Connect fuel tube from engine to fuel shutoff valve.
Figure 26: Draining Fuel from Fuel Tank
F. REMOVAL/INSTALLATION OF THE ENGINE AND GENERATOR AS
A UNIT
WARNING:
• THE COMBINED WEIGHT OF THE ASSEMBLED ENGINE AND GENERATOR IS APPROXI-
MATELY 125 POUNDS. USE OF AN OVERHEAD LIFTING DEVICE IS RECOMMENDED.
• INJURY TO MAINTENANCE PERSONNEL MAY RESULT FROM ATTEMPTING TO LIFT THE
HEAVY ENGINE AND GENERATOR ASSEMBLY FROM THE FRAME WITHOUT THE AID OF A
LIFTING DEVICE.
NOTE:
• Refer to exploded view in Replacement Parts section for parts information. The item numbers in
the following procedure are identical to those in the Replacement Parts exploded views.
• Tsurumi recommends that the heavy engine and generator assembly be removed from the frame
before removing generator components.
• The engine and generator wires have in-line plug and socket connectors that can be disconnected
to take electrical measurements or to allow component replacement. Tag both ends of the wires as
they are disconnected. Write the wire color and/or other characteristics (such as color of stripe) on
the tag to assure the wires are properly reconnected.
Page 47
Removal/Installation
Tsurumi’s Operation, Service, and Repair Manual
Drain tube
H-13
Fuel
Container