HP Photosmart D5400 series - Manual (Page 208)

Prepare the product for shipment
If, after contacting HP support or returning to the point of purchase, you are requested to send the
HP Photosmart in for service, make sure you remove and keep the following items before returning
your product:
• The control panel faceplate
• The power cord, USB cable, and any other cable connected to the HP Photosmart
CAUTION: The replacement HP Photosmart will not be shipped with a power cord. Store
the power cord in a safe place until the replacement HP Photosmart arrives.
• Any paper loaded in the input tray
This section contains the following topics:
• Secure the ink system
• Remove the control panel faceplate
Secure the ink system
Contact HP support for information about how you should secure the ink system to prevent ink from
leaking in the HP Photosmart during shipment. They might instruct you to replace the ink cartridges
with replacement ink cartridges.
If you receive a replacement HP Photosmart, refer to the instructions included in the box for
information about how to secure the ink system. The replacement HP Photosmart might come with
ink cartridges that you can use to install in your product to prevent the ink system from leaking during
shipment.
NOTE: This information does not apply to customers in Japan. For information on service
options in Japan, see “HP Quick Exchange Service (Japan)” on page 206 .
Related topics
“Replace the ink cartridges” on page 61
Remove the control panel faceplate
Remove the control panel faceplate before returning the HP Photosmart for repair.
NOTE: This information does not apply to customers in Japan. For information on service
options in Japan, see “HP Quick Exchange Service (Japan)” on page 206 .
CAUTION: The HP Photosmart must be unplugged before following these steps.
To remove the control panel faceplate
1. Press the On button to turn off the product.
2. Unplug the power cord, and then disconnect it from the product. Do not return the power cord
with the product.
3. Remove the control panel faceplate as follows:
a. Place your hands on each side of the control panel faceplate.
b. Use your fingertips to pry the control panel faceplate off.
Prepare the product for shipment 207
HP wa
rranty
and
sup
port