Ink is not filling the text or graphics completely – HP Photosmart D5400 series User Manual
Page 87
Ink is not filling the text or graphics completely
Try the following solutions if the ink is not filling the text or image completely so that it
appears that parts are missing or blank.
•
Solution 1: Make sure you are using genuine HP ink cartridges
•
Solution 2: Check the ink cartridges
•
Solution 3: Check the print settings
•
Solution 4: Check the paper type
•
Solution 5: Clean the print head
•
Solution 6: Contact HP support
Solution 1: Make sure you are using genuine HP ink cartridges
Solution: Check to see if your ink cartridges are genuine HP ink cartridges.
HP recommends that you use genuine HP ink cartridges. Genuine HP ink cartridges
are designed and tested with HP printers to help you easily produce great results,
time after time.
NOTE:
HP cannot guarantee the quality or reliability of non-HP supplies. Product
service or repairs required as a result of using a non-HP supply will not be covered
under warranty.
If you believe you purchased genuine HP ink cartridges, go to:
Cause: Non-HP ink cartridges were being used.
If this did not solve the issue, try the next solution.
Solution 2: Check the ink cartridges
Solution: Check the estimated ink levels in the ink cartridges.
NOTE:
Ink level warnings and indicators provide estimates for planning
purposes only. When you receive a low-ink warning message, consider having a
replacement cartridge available to avoid possible printing delays. You do not need
to replace the ink cartridges until print quality becomes unacceptable.
If there is ink remaining in the ink cartridges, but you are still noticing a problem, print
a self-test report to determine if there is a problem with the ink cartridges. If the self-
test report shows a problem, clean the print head. If the problem persists, you might
need to replace the ink cartridges.
For more information, see:
•
“Check the estimated ink levels” on page 60
•
“Print and evaluate a self-test report” on page 65
•
“Clean the print head” on page 64
Cause: The print head needed to be cleaned or there was insufficient ink.
If this did not solve the issue, try the next solution.
Chapter 11
86
Troubleshooting
T
roub
les
hoot
ing