Freescale Semiconductor 802.15.4 - Manual (Page 33)

Freescale Semiconductor Embedded Bootloader Reference Manual, Rev. 0.0 4-7
5. Make a copy of the NVM sector (both NVM0 and NVM1) with the production data.
Select the “PEDebug” menu, select “Programming Options”, and then choose “Start Expert Mode
Programmer”. The “Programmer Expert” window appears as shown in
Figure 18 .
Figure 18 Programmer Expert Window
6. In the “Programmer Expert” window, click on “UR Upload Range”. The “Start Address” window
appears as shown in Figure 19 . Here you specify the start address for the NVM section. Click the
“OK” button. For NVM0 use 0x152F and for NVM1 use 0x172F.
Figure 19 Start Address Window
7. In the “End Address” window, which looks very similar to the “Start Address” window, specify the
end address for the NVM section and then click the “OK” button. For NVM0 use 0x155B and for
NVM1 use 0x175B.