Freescale Semiconductor 802.15.4 User Manual
Page 35
Freescale Semiconductor Embedded Bootloader Reference Manual, Rev. 0.0
4-9
The Embedded Bootloader is now programmed to the PCB as shown in
Figure 22
.
Figure 22 Status Window
12. Write NVM production data back by selecting the “PEDebug” menu. Then select “Programming
Options” and “Start Expert Mode Programmer”. Select “SS Specify S-record” and locate the
PD_NVM.s19 file built in
. Select the “PM Program Module” option and production data is
written to flash.
13. Remove power and disconnect the BDM cable from PCB. Next, power up the PCB.
The PCB is now ready to upload an application. See
for more information about how to
upload an application.
NOTE
The applications must have the production section in the NVM cleared.
That is, the application image must contain 0xFF's in the production data
section of the NVM.