MK Diamond Products MK CX-3 - Manual (Page 36)

MK CX-3 Revision 09/04, Effective Date September 17, 2004 Page 36
MAINTENANCE AND TROUBLESHOOTING
(J)
Remove the old Micro-V belt from
the Engine and Blade Shaft Pulleys
(L)
Obtain and install a new
Micro-V belt onto the Engine
Blade Shaft Pulleys
(M)
Verify the Micro-V belt is seated in
all grooves of the Engine and
Cutting Drum Pulleys
(K)
Clean and verify the alignment of
the Engine and Blade Shaft
Pulleys
(P)
Repeat Steps N and O until Proper
Tension is achieved
Engine
Pulley
(N)
Tighten the Motor Tension Arm
using a 1/2-inch Wrench
(O)
Check Micro-V belt for proper
tension, if tension is correct (Proper
tension is approximately 1/8-inch
deflection of the belt)
(Q)
Tighten the Engine Mounting
Bolts using two 1/2-inch wrenches
(R)
Install the Belt Guard and Belt
Guard Retaining Screws
(S)
Install the Blade
(See Blade Removal /Installation
section)
Diamond
Blade
Old Micro-V belt
Blade Shaft
Pulley New Micro-V belt
Verify V-belt
seated
Tension
Arm
Check Tension 1/2-way
between pulleys
Repeat until
Correct
Rotate clockwise to
tighten
Turn clockwise
to tighten