Invacare 1048920 User Manual

Safety summary

Advertising
background image

Part No 1046525

1

Back Cane Replacement Kits for 9000 Series

For more information regarding Invacare products, parts, and services,

please visit www.invacare.com

Back Cane Replacement Kits
for 9000 Series Wheelchairs

Kit Nos. 1048919, 1048920, 1048921, and 1048922

NOTE: These instructions apply to the 9000 XT/XDT and the 9000 SL with adjustable 
back angle option.

NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact 
Carrier/Invacare for further instructions.

Safety Summary

ƽ WARNING

DO NOT install this equipment without first reading and understanding this

instruction sheet. If you are unable to understand the warnings, cautions and

instructions, contact a healthcare professional, dealer or technical personnel

if applicable, before attempting to install this equipment - otherwise, injury or

damage may occur.
Invacare products are specifically designed and manufactured for use in

conjunction with Invacare accessories. Accessories designed by other

manufacturers have not been tested by Invacare and are not recommended

for use with Invacare products.
After ANY adjustments, repair or service and BEFORE use, make sure that

all attaching component parts are secure.

NOTE: For this procedure, refer to FIGURE 1.

1. Remove the two mounting screws and washers that secure the back upholstery 

to the back canes (Detail “A”).

2. Remove the two mounting screws, locknuts, and (for wheelchairs 

manufactured after 11/1/2005) spacers that secure one back cane to the 
wheelchair frame (Detail “C”).

3. Pull the loose back cane out of the back upholstery.

4. Slide a new back cane through the back upholstery.

5. Secure the new back cane to the wheelchair frame at the desired back height 

with the two mounting screws, locknuts, and (for wheelchairs manufactured 
after 11/1/2005) spacers (Detail “B”).

NOTE: For wheelchairs manufactured after 11/1/2005, the spacers must be on the outside 
of the wheelchair in order for the mounting screws to be properly tightened (Detail “C”).

Assembly, Installation and Operating Instructions

SAVE THESE INSTRUCTIONS

Advertising
This manual is related to the following products: