Intel SX220 - Manual (Page 33)

Viglen SX220 User Guide 32
Routing Cables
Figure 12: Routing Cables
1. Route the backplane power cable (A) from the power supply to the backplane
board and connect it to the white 6-pin connector.
2. Route the server board power cable (B) from the power supply to the cable clip
and connect it to the white 24-pin connector on the server board. Firmly press the
two connectors together until they are fully seated.
3. If you are not installing a tape drive, coil the tape drive power cable, wire tie the
coil, and place it on the floor.
4. Route the auxiliary signal cable (I) from the power supply to the server board and
connect it to 5-pin auxiliary signal connector.