ILY Enterprise CoolCopy 7 - Manual (Page 23)

Copyright ©2005 by ILY Enterprise Inc.
All Rights Reserved.
23
Use arrow button to select Eject All Disc,
then press ENT or press ESC to return to 11-
09 menu.
Use arrow button to select Do Not Eject. Then press
ENT or press ESC to go back 11-09 menu.
4.11.10 Burn on the Fly
This setting lets you controls the burning methods. When the setting is “On”, the data will copy
directly from source drive to the target drives. When the setting is “Off”, the data will load into a
partition of the hard drive first. Then, the copying will be completed.
Press ENT button to enter Burn On The Fly.
Use arrow button to change the On or Off
Setting. Then press ENT or press ESC to return to
The 11-10 menu.
If the system does not connect with hard drive,
the LCD will show the following message.
4.11.11 Burn Mode
This setting lets you control the burning methods. There are two modes: Disc At Once (DAO) or
Track At Once (TAO). Default setting is DAO. Some CD writers may support different writing
methods. If the method selected is not supported, duplicator will automatically switch to the other
one.
.
Press ENT button to enter Burn Mode.
Use arrow button to change TAO or DAO
mode setting. Then press ENT or press ESC
to return to 11-11 menu.
4.11.12 Button Sound
This setting allows you to control the sound when you press it.
Press ENT button to enter Button Sound.
Use arrow button to change On or Off
setting. Then press ENT or press ESC to return to
11-12 menu.
Eject Disc
Eject All Disc
Eject Disc
Do Not Eject
11-10. Setup
Burn On The Fly
Burn On The Fly
On
There is no HDD !
11-11. Setup
Burn Mode
Burn Mode
DAO
11-12. Setup
Button Sound
Button Sound
On