ILY Enterprise CoolCopy 7 - Manual (Page 5)

Copyright ©2005 by ILY Enterprise Inc.
All Rights Reserved.
5
Supported CD-ROM Drives* - EPO, TEAC
Supported CD-RW Drives* - Plextor, TEAC, Lite-On, Asus, SONY
Chapter 2 Installation Procedure
When you receive the Coolcopy CD Duplicator, the package could be packaged in the following
ways: controller only, whole duplicator without writer installed, and a complete duplication system.
2.1 Controller only
1. Before the installation, please prepare the necessary devices as following:
• CD-ROM drive
• CD-R/RW drive
• IDE case (2~10-bay chassis suggested).
• Hard drive and mobile rack (IDE-bus hard drive-Option)
• Switching power supply (300W suggested).
2. After the preparation as above and make sure that:
• All IDE devices must be in master mode.
2.2 Whole duplicator without writer installed
• Unpack the package of the duplicators.
• Prepare the CD-R/RW writers according to the recommendation list. Please check with
the supplier about compatibility issues with unlisted CD-R/RW drives.
• Assemble the duplicator according to your need.
• Make sure that the voltage setting is correct.
2.3 Completed duplication system
• Take the duplication system out of the package.
• Check the entire unit to see if there are any problems.
• Make sure that the voltage setting is correct.
• The hard drive is optional.
Hardware Connection of CoolCopy1AL (CD-Backup) without a HDD
CoolCopy1AL (CD-Backup)
CD-Rom
CD-RW
Power