ILY Enterprise 3 - Manual (Page 26)

Copyright©2005 ILY Enterprise, Inc. All rights reserved. 26
the data and update its firmware automatically. During updating, do not turn off the power of
machine because the update will not be finished until machine resets itself.
The Update Firmware function updates firmware to the latest version.
2. Unzip the firmware you have and write the file “cdxxx.bin” into the root directory of a blank
DVD-R or DVD-RW disc. You have to close the DVD session. If the same DVD disc still has
capacity to add more data, it can be used to store newer versions of the firmware. When updating
the firmware program from the DVD, only the one from last session will be used. Versions from
previous sessions will be ignored.
Select the source drive to the DVD-ROM first! Then
press the ENT button to enter UpdateFirmware.
The system will search the new firmware from the
DVD and the LCD will show the process as shown here:
When the new firmware is found, press the ENT
button. The system will update it.
4.12.8 Compare Firmware
This function will help you compare the current control firmware version with the updated version
when the firmware disc is placed into the DVD-ROM.
Press the ENT button to enter Compare Firmware.
.
4.12.9 H/W Diagnostic
This function will detect what devices are connected with the control. The LCD will display the
hardware information.
Press the ENT button to enter H/W Diagnostic.
The LCD will ask the user to do the button test. Following
the LCD instruction, test each function button.
After the button function testing, the system will perform the SDRAM self-test, the hardware
connecting test, and the flash test. Every testing process will be shown on the LCD. It just takes a
few minutes to get the results of hardware diagnostics. It is an easy way to know if the system
works properly.
When testing is finished, the LCD will show the
“Test finished” message. Press the ESC button to
go back to the 12-09 menu.
4.12.10 Load Default
This function will reset any previous settings back to the factory’s default setting. Different
settings will cause duplicator to react differently.
12-07. Adv Setup
Update Firmware
Searching F/W---
XXX/XXXXX
12-08. Adv Setup
Compare Firmware
12-09. Adv Setup
H/W Diagnostic
Enter ESC
Hold ESC to exit
Test finished