9 others, 10 note for 100base-tx connection, Ad-081ge – JAI AD-081GE User Manual
Page 33
AD-081GE
32
If it is not shown, confirm the setting in the “Settings” window. Access the “Settings”
window by clicking on the “Settings Tab” icon.
10.2.9 Others
IF “Receive Descriptor” is set at its maximum value, picture disturbance may occur
due to “Hyper Threading” mode. If this happens, check that “Hyper Threading” is set at
OFF. This is set in BIOS.
When the image is being captured, if the frame rate decreases, change the packet size.
Each packet contains the header data and when the packet size is small, the total data
including header information will increase. Depending on the performance of the
computer used, the frame rate may be decreased. Confirm the packet size is increased.
It can be set in the Camera Control Tool provided in JAI SDK.
10.2.10 Note for 100BASE-TX connection
In order to use 100Mbps network, 100BASE-TX and Full Duplex are available. Half Duplex
cannot be used.
In the case of connecting on 100BASE-TX, the maximum packet size should be 1500
bytes.
In the case the of connecting on 100BASE-TX, the specifications such as frame rate,
trigger interval and so on described in this manual cannot be satisfied.
Pixel Type
Frame rate at Full Frame scan[fps]
MONO8
Approx. 12
MONO10_PACKED,MONO12_PACKED
Approx. 8
MONO10, MONO12
Approx. 6
Note: The above frame rates are based on total data of 70Mbps.