J. T. Eaton Liquid-Cooled Drives LCX9000 - Manual (Page 101)

LCX9000 Liquid-Cooled Drives User Manual
MN04005001E For more information visit: www.EatonElectrical.com 5-25
January 2007
Hardware Settings
Note: The Hardware settings submenu is protected with a password. Store the password in a
safe place!
In the Hardware Settings submenu (S6.7) under the System menu, you can further control
some functions of the hardware in your drive. The functions available in this menu are HMI
acknowledge timeout and HMI retry.
HMI Acknowledge Timeout (P6.7.3)
This function allows the user to change the timeout of the HMI acknowledgement time. The
drive waits for the HMI acknowledgment in accordance with the value of this parameter.
Note: If the drive has been connected to the PC with a normal cable, the default values of
parameters 6.7.3 and 6.7.4 (200 and 5) must not be changed.
If the drive has been connected to the PC via a modem and there is a delay in transferring
messages, the value of parameter 6.7.3 must be set according to the delay as follows:
Example:
● Transfer delay between the drive and the PC = 600 ms
● The value of par. 6.7.3 is set to 1200 mS (2 x 600, sending delay + receiving delay)
● The corresponding setting shall be entered in the [Misc] part of the file NCDrive.ini:
– Retries = 5
– AckTimeOut = 1200
– TimeOut = 6000
● It must also be considered that intervals shorter than the AckTimeOut time cannot be
used in NC-Drive monitoring.
Enter the edit mode by pressing Menu Button Right. The current value starts to flash. Use the
Browser buttons to change the acknowledgement time. Confirm the change with the ENTER
button or return to the previous level with Menu Button Left.
Figure 5-23: HMI Acknowledge Timeout
HMI ACK timeout
P6.7.3 P6.7.3
HMI ACK timeout
200ms 200ms