Jameco Electronics Rabbit 3000 User Manual
Page 116
User’s Manual
107
Table 7-19. Input Capture Control/Status Register
Input Capture Control/Status Register
(ICCSR)
(Address = 0x56)
Bit(s)
Value
Description
7:2
(read)
These status bits (but not the interrupt enable bits) are cleared by the read of this
register, as is the Input Capture Interrupt.
7
0
The Input Capture 2 Start condition has not occurred.
(read)
1
The Input Capture 2 Start condition has occurred.
7
0
The corresponding Input Capture 2 Start interrupt is disabled.
(write)
1
The corresponding Input Capture 2 Start interrupt is enabled.
6
0
The Input Capture 2 Stop condition has not occurred.
(read)
1
The Input Capture 2 Stop condition has occurred.
6
0
The corresponding Input Capture 2 Stop interrupt is disabled.
(write)
1
The corresponding Input Capture 2 Stop interrupt is enabled.
5
0
The Input Capture 1 Start condition has not occurred.
(read)
1
The Input Capture 1 Start condition has occurred.
5
0
The corresponding Input Capture 1 Start interrupt is disabled.
(write)
1
The corresponding Input Capture 1 Start interrupt is enabled.
4
0
The Input Capture 1 Stop condition has not occurred.
(read)
1
The Input Capture 1 Stop condition has occurred.
4
0
The corresponding Input Capture 1 Stop interrupt is disabled.
(write)
1
The corresponding Input Capture 1 Stop interrupt is enabled.
3
0
The Input Capture 2 counter has not rolled over to all zeros.
(read)
1
The Input Capture 2 counter has rolled over to all zeros.
3
0
No effect on Input Capture 2 counter. This bit always reads as zero.
(write)
1
Reset Input Capture 2 counter to all zeros and clears the rollover latch.
2
0
The Input Capture 1 counter has not rolled over to all zeros.
(read)
1
The Input Capture 1 counter has rolled over to all zeros.
2
0
No effect on Input Capture 1 counter. This bit always reads as zero.
(write)
1
Reset Input Capture 1 counter to all zeros and clears the rollover latch.
1:0
0x
Normal Input Capture operation.
x0
Normal Input Capture operation.
11
Reserved for test. The Input Capture counter increments at both bit 0 and bit 8.
There is no carry from lower byte to higher byte.