Sub-Zero ICB424 - Manual (Page 29)

29
K I C K P L AT E A N D G R I L L E
After the unit has been leveled, make sure the
drain pan is installed properly and install the
kickplate. Refer to illustration 7 below.
IMPORTANT NOTE: The kickplate must be
removed for servicing. The floor cannot inter-
fere with removal. Refer to label mounted on
the kickplate support for height clearance.
IMPORTANT NOTE: The floor under the Wine
Storage unit must be at the same level as the
surrounding finished floor to allow for removal
of the unit for servicing.
Replace the grille by reversing the procedure
outlined on page 26. If you’re using a panel
grille, see Overlay Grille Panel on page 31.
Turn power back on to the electrical outlet.
D O O R P A N E L S
Model ICB430 is offered in two design applica-
tions; stainless steel (/S) and overlay (/O). Each
of these designs is available as a glass door
(G) model.
The stainless steel Model ICB430 is available in
the classic finish only and is shipped from the
factory with the decorative stainless steel door
panel and matching handle in place.
The overlay Model ICB430/O is designed to
accept a decorative door panel to match
surrounding cabinetry. This door panel and the
handle will be provided by the customer.
Before beginning installation, check for the
correct components for the fit and finish
desired. All models require a decorative panel
a minimum of 16 mm thick.
Illus. 7
M O D E L I C B 4 3 0 I N S T A L L A T I O N I N S T R U C T I O N S
P A N E L
D E S I G N
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
M O D E L
I C B 4 3 0