Lowrance electronic LMF-400 - Manual (Page 10)

8
Add a new device to a NMEA 2000 bus by attaching a T connector
between two T connectors, between a T connector and the end
terminator, or between two backbone extension cables.
If you want to add a node at the end of the line (as shown in the previous
figure), remove the terminator from the very last connector, securely
attach the new T connector, and then attach the terminator on the new
connector. Either method will allow you to add a device.
Additional Network Information
Further instructions on creating or expanding a LowranceNET network
are illustrated in the NMEA 2000 network setup booklet, part number
988-0154-172, which came packed with this manual.
Existing network
node
Attach
terminator at
end of bus.
Lowrance or LEI device con-
nects to new T connector. Add T-shaped con-
nector to add device
to bus.