Lowrance electronic LMF-400 - Manual (Page 40)

38
1. From the Fuel Setup menu, select R ST T RIP F UEL
and press Enter,
which will launch the following message: Press Enter to Reset Trip
Fuel.
2. Press
ENTER , which will take you back to the Fuel Setup menu. Press
EXIT repeatedly to return to the main display.
System Setup Menu
To get to the System Setup menu, press MENU , then scroll down to
System Setup and press ENTER . The System Setup menu contains :
Engine Displayed, Bus Devices, Sonar Alarms, Eng/Tank
Configuration, Reset Values, System Information and Change Units.
Engine Displayed
The Engine Displayed command allows you to monitor up to three
engines on your vessel.
Basic menu with System Setup highlighted (left). System Setup menu
(right) with Engine Displayed selected.
1. After accessing the System Setup menu, highlight E NGINE D ISPLAYED
and press ENTER . A menu will appear with the following options: Port,
Center and Starboard. This is important when viewing information like
Fuel Management, RPM and Engine Voltage.
2. Select the engine you would like to monitor and press
ENTER .
Bus Devices
1. To run a system check for devices connected to the NMEA 2000
network, choose
B
US
D
EVICES
from the System Setup menu and press
ENTER. After a Searching for Bus Devices message comes up, a list of
all devices attached to the LowranceNET — the Bus Devices list — will
appear.
Sonar Alarms
1. If you would like to set Deep or Shallow Sonar Alarms, select
S
ONAR
A LARMS
from the System Setup menu and press ENTER . An alarm menu
will pop up with two choices: Shallow or Deep.