Lowrance electronic LMF-400 - Manual (Page 23)

21
In the following example, we want to swap the configuration of Temp 2
and Temp 1. We will first unconfigure Temp 2, then reconfigure Temp 1
as Temp 2. We'll finish by configuring UnCfg Temp (formerly Temp 2)
as Temp 1.
1. Highlight T EMP 2 on the Bus Devices list and press ENTER , which will
launch the temp sensor configuration menu.
2. Choose U
NCONFIGURE
and press ENTER . The following message will pop
up: Hit Menu to UnCfg Temp Sns.
3. Press ENTER , and you will be taken back to the Bus Devices list.
4. Select T EMP 1 from the Bus devices menu and press ENTER . Choose
R
ECONFIGURE
and press ENTER . That will direct you to the Temp
Selection menu.
5. Select T
EMP
2 and press ENTER , which will take you back to the Bus
Devices list.
6. Now highlight U
N
C
FG
T
EMP
from the Bus Devices list and press ENTER ,
which will call up the Selecting Temp menu. Choose one of the Temp
options (Temp 1, Temp 3, etc.) and press
ENTER . You will be returned to
the Bus Devices list.
NOTE:
To run a system check for devices connected to the NMEA 2000
network, select
B US D EVICES
from the System Setup menu and press
ENTER . A Searching Bus Devices message comes up, followed by a
list of all devices attached to the LowranceNET — the Bus Devices
list. To select an item from the bus devices list, use the
UP and
DOWN keys to scroll through the list. Highlight the desired category
and press ENTER .
Fuel Flow (Port, Center and Stbd)
Port Fuel Flow (Port Fflow), Center Fuel Flow (Cen Fflow) and
Starboard Fuel Flow (Stbd Fflow) all share the same internal
configuration menu, which includes: Change Engine (for two or more
engines only), Fuel Warning, Unset Engine and Reset Values. After
selecting a Fuel Flow (Port, Center or Stbd) from the Bus Device list
and pressing
ENTER , the following options will appear in the menu.
To Unconfigure Fuel Flow:
See Unset Engine below.
To Configure Fuel Flow:
1. From the Bus Devices list, highlight U
N
C
FG
F F
LOW
and press ENTER .
That will launch the following message: Hit Menu to Cfg Flow Sns.
2. Press ENTER to proceed with configuration.