LightSpeed Technologies Delta X10 - Manual (Page 24)

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
22
Wireless Transmitter
Handheld Microphone
•Switch the transmitter power off.
•Insert the small DC plug
into the jack on the bottom
of the transmitter.
•Plug the other end of the charger
into any standard 110 VAC outlet.
•The Red LED on the charger will light
indicating that charging is in progress.
•When the batteries are fully charged,
the light on the charger will turn green.
A full charge can take up to 8 hours.
REPLACING THE BA REPLACING THE BA REPLACING THE BA REPLACING THE BA REPLACING THE BATTERIES TTERIES TTERIES TTERIES TTERIES
1. 1. 1. 1. 1. To replace the batteries, unscrew the end cap to reveal the battery compartment.
2. 2. 2. 2. 2. Remove or replace the batteries as shown. The microphone requires two AA sized batteries stacked end to end.
3. 3. 3. 3. 3. Note the polarity in the battery compartment. Typical battery life is about 8 hours.
CHARGING THE BA CHARGING THE BA CHARGING THE BA CHARGING THE BA CHARGING THE BATTERIES (NiMH Rechargeable Batteries ONL TTERIES (NiMH Rechargeable Batteries ONL TTERIES (NiMH Rechargeable Batteries ONL TTERIES (NiMH Rechargeable Batteries ONL TTERIES (NiMH Rechargeable Batteries ONLY) Y) Y) Y) Y)
Make sure there are NiMH Rechargeable Batteries in the transmitter before plugging in the charger.
WARNING: Do not attempt to charge alkaline batteries. They can
overheat and expand, creating a significant hazard and damaging
the transmitter.
(This is not covered by warranty.)
Transmitter
Charger
Charger
Connector
Charger Status LED
• RED = charging in progress
• GREEN = batteries fully charged
LOCK SET
HM-900
Handheld Microphone
End View
2 3
ON
1
End Cap
IMPORTANT! Replace batteries with the same type, (alkaline or NiMH),
that were installed in your handheld microphone.
Operating Instructions O N